Questions tagged [abs]
8 questions
3
votes
0 answers
Forces on a wheel during braking (Quarter Vehicle Model)
I have created a simple xcos simulation for quarter wheel using the equations given at the bottom of the image.
I understand the total torque on the wheel will be the braking torque and the friction torque. My question was right till the end the…
amekha
- 31
- 1
2
votes
1 answer
How well does epoxy bond to PETG / ABS vs Wood?
I know that PLA does not bond at all, just peel right off
But i'm wondering about PETG or ABS
Will they bond just as well as wood?
Simon
- 103
- 7
1
vote
1 answer
Injection molding: What is best for a dual cavity single mold?
I would like to understand what's the best optimization in terms of design for a single mold, dual cavity of a two-part box (top and bottom parts) which should be hold together with 4 screws without any clip. For other reasons not drawn, both parts…
gregoiregentil
- 125
- 4
0
votes
0 answers
Can electronic brakeforce distribution (EBD) continuously vary the brake torque applied at each wheel?
It's a simple question, but I haven't been able to find an answer to it. Can an EBD system vary brake torque continuously, as opposed to the pulse-based mode of operation of the typical ABS?
jvf
- 101
- 2
0
votes
2 answers
Which glue is good for transparent ABS plastic and easy removal?
Hello all I need to glue some ABS plastic parts together some of them are transparent.
I used AA glue before but it will make my transparent parts foggy and after sticking them together its nearly impossible to disassembly.
So is there a better…
tempo3010
- 5
- 1
0
votes
0 answers
Long term deflection
I've been working with a team of 'designers' that are highly concerned over a potential failure mode of ABS plastic. Their theory is that under a static load well under the yield point of the material that a plastic ABS part will eventually stretch…
Diesel
- 632
- 5
- 18
0
votes
1 answer
Temperature vs Material Properties - ABS
I'm working on a design that uses fairly large plastic components (ABS, ~400mm longest dimensions). I'm looking at adding a steel component that encapsulates this plastic part. And, the steel part needs to be tight against the ABS part.
Because of…
Diesel
- 632
- 5
- 18
0
votes
1 answer
Material Properties of ABS
I've been working on a design that requires a plastic snap feature. I've assumed up to this point that the material will be injection molded ABS, with material properties I pulled off of matweb.
After several dozen iterations on the design, I've…
Diesel
- 632
- 5
- 18