Questions tagged [hinge]
5 questions
4
votes
1 answer
What is this locking pin for a hinge called?
The following is a picture of a locking pin for a tubular hinge which specifies Maritime use. I assume it has something to do with railings but I'm thinking of fabricating my own similar hinges. "Locking pin" seems awfully vague. I know I've seen…
Walter
- 51
- 3
4
votes
3 answers
Non-standard Door Hinge Spacing
The usual woodworker/house builder rule of thumb is to place the top hinge 6" (150 mm) from the top of the door, and the bottom one 9" (228 mm) from the bottom - the common reason for this is illusion of "foreshortening" and this results in a visual…
D Duck
- 411
- 2
- 8
0
votes
1 answer
What type of fastener / rivet is this please?
I think I may have worked this out but I would love it if a real engineer could confirm it please? Is the fixing shown in the photos a shoulder rivet? Semi tubular? For the record the pictures show a collapsible music stand, the metal legs shown…
JCP
- 1
- 2
0
votes
0 answers
Duplicate a sketch on a spiral like array of lines in solidworks
This one is gonna be hard for me to explain, but I hope you will get it
I have this sketch:
Each side of this part is half of it, to be easily duplicate / mirror / pattern
Important to note the both ends of this chain needs to be just the half (so…
Simon
- 103
- 7
-1
votes
1 answer
Hinge type 90degree max
I'm looking for a hinge
that can open a maximum of 90 degrees
will open fully by gravity alone
approx 20mm wide
approx 50mm long each arm
approx 10mm thick when closed
Is this something that can be sourced?
Could it be 3D printed?
user195166
- 125
- 4